Argonian face tutorial

Hello! How are you doing?

It's time for another LEGO tutorial! As you could see in the post 'What's next?', It is going to be an an Argonian (A humanoid reptile/amphibian) face. So here it comes:

part I: The lower jaw

picture                                                                             requirements/comments

3   8-knob bricks

It doesn't matter if you use red, black, or whatever color you use! You can use green/black, blue/yellow or anything else!

3   8-knob bricks
1   4-knob beam

3   8-knob bricks
2   6-knob bricks

keep this one with you, you will use this one later

Part II: the neck

yellow bricks can be replaced with any color bricks, as they won't be visible afterwards.

3   8-knob bricks
2   4-knob bricks
2   6-knob bricks
16-knob brick filling

2   4-knob bricks
3   8-knob bricks
1   16-knob brick

4   8-knob bricks
16-knob brick filling

6   4-knob bricks
1   4-knob beam
1   2-knob beam

3   8-knob bricks
2   6-knob bricks
1   4-knob beam
1   2-knob beam

2   6-knob bricks
2   2-knob beams

1   16-knob brick
3   8-knob bricks
2   2-knob beams

1   16-knob brick
2   8-knob bricks
1   4-knob beam

1   2-knob beam














3 8-knob bricks x2

attach it like this!

click you two creations together!













fill the little hole up with another 8-knob brick.


It's gonna get a little confusing now, watch these steps carefully!

Part III: the upper jaw

6   8-knob bricks
2   4-knob bricks

5   4-knob bricks
2   8-knob bricks
1   12-knob brick

4   8-knob bricks
2   4-knob bricks
2   12-knob bricks
1   16-knob brick
1   6-knob brick
2   2-knob beam

2   4-knob bricks
8   8-knob bricks
2   3-knob beams
1   12-knob brick

I noticed there shoul be another 4-knob beam on the tip of its nose that isn't there!

1   12-knob brick
7   8-knob bricks
6   4-knob bricks (2 eyes!)

1   16-knob brick
3   12-knob bricks
3   8-knob bricks
2   6-knob bricks
1   4-knob beam

Click the two parts together, and you have finished the building part!

Part IV: the decoration

add another two 2-knob beams for based for horns if you like it! anything I am describing now is not necessairy!

A possibility for a horn. you can also make sprial horns, no horns, or any horn you like!

The end result, with teeth added. I used the traditional up-down-up way of adding teeth. The corner teeth of the lower jaw are cones instead of tubes to make them look more sharp.